Answered
0
0

Hi there and thanks for your time to read this.I got this question when using FMOD Studio

I thought the effect added within Snapshot only works when Snapshot is triggered.but when I added Lowpass to a event group within the Snapshot,the lowpass effect has a direct effect on the group without Snapshot being triggered.So I wonder what else I need to do to get the event group stay unchanged until the Snapshot is triggered with lowpass to it.

hope to get your reply soon.Thanks a lot.

                             Shane
  • You must to post comments
Best Answer
1
0

Snapshots don’t yet support adding or removing effects from signal chains. However, they do allow you to assign different values to the properties of those effects – meaning that you should set the cutoff property of your Lowpass effect to the maximum kHz value normally, and assign it a much lower value in the snapshot, you will be able to “bring in” the Lowpass effect when the snapshot is triggered.

  • You must to post comments
Showing 1 result
Your Answer

Please first to submit.